If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below. Please note that by joining our forum you are agreeing to receive our quarterly newsletter via email.
I had a Buckskin Pedernales plate that had a thin layer of good chert in the center. I finally got down to the good chert after knapping away a lot of chalk and off white chert. The remaining biface was only about ten percent of the rock I started with. The finished blade is 3" long and 2.5" wide.
Michigan Yooper
If You Don’t Stand for Something, You’ll Fall for Anything
Comment